How to install the cyclone unit
Writer： admin Time：2020-11-03 10:13 Browse：℃
The cyclone group is a combination of cyclone equipment that requires strict installation steps before it can be used normally in the later stage. It is necessary to know that the cyclone group has a relatively strong separation capacity and high underflow solid content, so it needs to attract everyone’s attention in installation. . The hydrocyclone is a device used to separate and remove the heavier coarse particles of mud and sand in sewage. Sometimes it is also used for mud dewatering. There are two types, pressure type and gravity type. They are often made of circular column structures or metal pipes.
In production practice, there are four installation methods for hydrocyclones: formal installation, inverted installation, inclined installation and flat installation.
1. The erection position of the cyclone group:
When installing the cyclone group, pay attention to its starting point. The starting point of the dam should be the far point of the tailings dam, and the sand mouth of the cyclone must also be towards the far point of the dam. After working for a period of time, the underflow dam can be moved along the dam to continue stacking.
2. The problem of underflow stacking height:
When designing and installing the cyclone unit, the height of the water flow must be considered clearly. Generally speaking, it is enough not to block the underflow.
3. Mobility after installation:
The cyclone group needs to move from the starting point of the dam to the end of the dam during the dam construction process, so the requirements for the movement performance of the cyclone group are relatively high. One thing to note is to keep the same horizontal separation distance when moving.
4. The supporting feed pipe of the cyclone group:
The length of the feed pipe of the cyclone unit should reach a sufficient standard. When installing, judge according to the actual situation of the site and the equipment. In addition, the requirement of the feed pipe of the cyclone unit is that the corrosion resistance can be stronger.
1. Cyclone is installed
The axis of the cyclone is perpendicular to the horizontal line, the overflow port is on the top, and the sand sink is on the bottom. The cyclones for classification, desliming, concentration, clarification, and washing are mostly installed, especially for single cyclones.
2. Cyclone upside down
The axis of the cyclone is also perpendicular to the horizontal line, but the overflow port is on the bottom and the sand settling port is on the top, which is the opposite of the formal installation. The heavy medium cyclone in the sorting operation is sometimes upside-down.
3. Cyclone oblique installation
The axis of the cyclone is at an angle to the horizontal. Many cyclones arranged in groups or heavy medium cyclones for selection are mostly inclined installation.
4. Cyclone paperback
The axis of the cyclone is parallel to the horizontal line, so there are few applications. Only the cyclone with spiral discharge device for processing fibrous slurry is flat-mounted, and the oil-water separation cyclone is mostly flat-mounted.
The correct installation of the cyclone unit determines the normal use of the later equipment, so if you have any questions about the installation introduction above, you can consult Jiding Environmental Technology Co., Ltd. Do not operate blindly without understanding, to avoid installation failure in the later period A situation in which the equipment cannot work normally caused by normal occurrence.
