Installation steps of cyclone group
Writer： admin Time：2020-11-05 10:18 Browse：℃
The cyclone group is a combination of cyclone equipment that requires strict installation steps before it can be used normally in the later stage. It is necessary to know that the cyclone group has a relatively strong separation capacity and high underflow solid content, so it needs to attract everyone’s attention in installation. . What is the correct installation procedure for the cyclone unit? I believe many friends are not very clear. Today, the cyclone manufacturer will give you a brief introduction:
The cyclone group usually adopts two ways of vertical installation and horizontal installation. The vertical installation method of the cyclone is suitable for working conditions with large fluctuations in feed volume and large changes in circulating load. The horizontal installation of the cyclone is an installation method where the angle between the cyclone and the horizon is 15° to 20°, which is suitable for working methods with variable circulating loads and can provide a relatively stable underflow concentration. The installation of the cyclone group usually requires the manufacturer to provide technical support and is carried out under the guidance of professional technicians. However, in the later use, it is inevitable to disassemble and assemble occasionally. How to install it quickly without professional guidance.
1. The erection position of the cyclone group:
When installing the cyclone group, pay attention to its starting point. The starting point of the dam should be the far point of the tailings dam, and the sand mouth of the cyclone must also be towards the far point of the dam. After working for a period of time, the underflow dam can be moved along the dam to continue stacking.
2. The problem of underflow stacking height:
When designing and installing the cyclone unit, the height of the water flow must be considered clearly. Generally speaking, it is enough not to block the underflow.
3. Mobility after installation:
The cyclone group needs to move from the starting point of the dam to the end of the dam during the dam construction process, so the requirements for the movement performance of the cyclone group are relatively high. One thing to note is to keep the same horizontal separation distance when moving.
4. The supporting feed pipe of the cyclone group:
The length of the feed pipe of the cyclone unit should reach a sufficient standard. When installing, judge according to the actual situation of the site and the equipment. In addition, the requirement of the feed pipe of the cyclone unit is that the corrosion resistance can be stronger.
The vertical installation method of the cyclone group is suitable for the working conditions with large fluctuations in the feed volume and large changes in the circulating load. The horizontal installation of the cyclone group is to install the cyclone group at an angle of 15° to 20° with the horizon. It is suitable for working with variable circulating loads and can provide a relatively stable underflow concentration. If the cyclone adopts a distributor and multi-cyclone substructure, in order to reduce unnecessary turbulence, a straight pipe section should be provided for the inlet pipe of the distributor, and the length of the pipe should not be less than 9 times the pipe diameter. When installing the overflow pipe and feed pipe of the cyclone group, if the feed pipe is arranged below the overflow discharge pipe, pay attention to setting up a vent pipe for the overflow elbow to ensure smooth gas flow.
The correct installation of the cyclone unit determines the normal use of the later equipment, so if you have any questions about the installation introduction above, you can consult our manufacturer. Do not operate blindly without understanding, to avoid abnormal installation in the later period. A situation where the equipment does not work normally occurs.
